![]() Unganged mode enables two 64bit wide DRAM Controllers (DCT0 and DCT1). Ganged mode means that there is a single 128bit wide dual-channel DRAM Controller (DCT)Įnabled. Ganged vs Unganged: that actually doesn't have to do with single or dual channel. Great article, Tradesman! I give it Two thumbs up and two big toes up too! Go to START, and type MSCONFIG in the search box. Look in MSCONFIG and see if Windows is limiting your DRAM. If nothing changes, you'll have to take it to a shop or RMA the motherboard and/or the CPU. Pull the CPU and check for these and other problems. You may have bent or broken pins there may be debris or thermal compound in the socket or on the bottom of the CPU. Oftentimes, the CPU cooler gets tightened too much in a corner or side, which can throw the CPU out of level so all the pins don’t make full contact, and that can result in an error. Your CPU cooler may not be installed correctly. If that’s the case, first try loosening the CPU cooler, then snugging it back down, but not overly tight. If both show up and the full amount of DRAM appears in one combination but not the other, then the one that doesn’t show may be bad, or the MC might be bad. If the memory modules are in slots one/three, try them in one/two and see what you have, and then try them in three/four. It could be a bad channel on the motherboard or the memory controller (MC) located in the CPU. If you determine it’s a single bad slot, then it’s time to RMA the motherboard. Some motherboards show a preference for one set of slots or the other. If they were in slots one/three, then try them in two/four. Pull the modules and blow out the slots with compressed air. If you have another set of DRAM available, try those. If both boot up the rig, then move to he next suggestion. Check each DIMM individually to ensure it can boot the system by itself. Q-Tips or cotton swabs can leave fibers on the contacts. I suggest using foam swabs and isopropyl alcohol (rubbing alcohol). This can have a number of causes: You may have a bad DIMM. For example, it may show only one DIMM even if two are installed, or it may be showing both but only half the amount of DRAM that it should. Ensure that it’s showing the full amount of DRAM installed. It’s possible the system isn’t seeing your entire amount of DRAM.You can manually set the DRAM to unganged (basically, single-channel mode) or ganged (dual-channel mode) regardless of which slots the modules are in. If it’s an AMD motherboard, there is often a setting in the BIOS for ganged or unganged mode.If you’re using an odd number of memory modules on a dual-channel motherboard, you can use flex mode, which allows different sizes of DIMMs to work together. Most dual-channel motherboards color-code the slots for you to fill for dual-channel operation. Generally, a four-slot motherboard should use (from the CPU) slots one and three or slots two and four for a two-DIMM setup, or slots one through four for a four-DIMM setup. Your manual should show the correct slots for the DRAM. The memory modules may not be in the proper slots. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |